When it comes to making sure that no students are left on board, school bus drivers have a vital responsibility after every run: walk to the back of the bus and check for sleepers.
Yet students continue to be left on school buses, sometimes not being discovered for several hours. Young children can be stranded on a very hot or very cold bus, or they might disembark and wander off in an unknown area. Clearly, the stakes are high.
While there may be school bus drivers out there who would intentionally avoid walking to the back of the bus to check for students, even conscientious drivers can be susceptible to getting distracted by a change in routine. A reminder to check the bus serves everyone well.
There is a variety of electronic systems on the market that can provide just such a reminder, requiring drivers to go to the back of the bus to push a button or scan a tag.
Of course, it’s still up to the driver to keep his or her eyes peeled during that walk along the bus aisle.
Driver reminder and more
Child Check-Mate System’s flagship device, the EP 1, positions a button at the back of the bus that drivers have to press at the end of a run to disarm the system.
The newer EP 2 allows for several features in addition to the driver reminder: the Theft-Mate accessory, a speaker and a key fob.
The speaker gives the driver voice commands to perform the child check. The key fob allows technicians and managers to board the bus without setting off the alarm.
Theft-Mate uses motion detection to scan the interior of the bus — both for students and for intruders — after the driver has left.
“Within the first hour after the check has been performed, if there’s a child left on the bus and there’s movement, the system will ask the child to stay on the bus and will let him or her know that someone will be with them shortly,” says Gord Both, president of Child Check-Mate System. “After the first hour, it turns into a vandal deterrent.”
The EP 2 can also be connected to a GPS system, allowing it to give the transportation office instant messages if an alarm goes off, as well as other updates.
“No. 1, you need to know if the system is in operation each day, and it tells you that,” Both says. “No. 2, it tells you when the checks are done. No. 3, it tells you if it goes off.”
Electronic inspection tool
Zonar’s Electronic Vehicle Inspection Report (EVIR) system can also help prevent children from being left on school buses.
A radio-frequency identification (RFID) tag is placed at the back of the bus. Before and/or after a run, the driver has to walk to the back of the bus and scan the tag there as part of a comprehensive vehicle inspection.
“When the driver scans the tag, the date and time are recorded, so you know the exact time it was checked,” says Andrew Johnson, director of marketing for Zonar. “The fleet manager can run a report confirming that the child check was completed.”
Also, with Zonar’s Ground Traffic Control software, managers can set up an alert to notify them if an inspection is not completed.
For the inspection, drivers use either Zonar’s flagship 2010 EVIR hand-held reader or the new 2020 tablet, which offers numerous additional features, including an hours-of-service application, instant driver feedback, fuel efficiency tracking, two-way messaging and advanced navigation.
